Scientific journal
Scientific Review. Technical science
ISSN 2500-0799
ПИ №ФС77-57440

ANALYTICAL MODEL OF A SPEED MODE TAPER CLASSIFIERGN

Vakhnina G.N. 1 Knyazev A.V. 1 Losev S.S. 1
1 Voronezh State Academy of Forestry Voronezh
Classifiers were developed the advanced of a resource-saving technology for the first time implemented a comprehensive pre-treatment of seeds. Results are obtained calculating the rate case with the lattice on the analytical models. In these equations, the first, is recorded design and settings designed classifier cone width of frame, diameter of the top of the sieve, the average diameter of the large sieve, the average diameter of the smaller sieve diameter of the bottom of the sieve, the slope of the body, the position of the horizontal framing members. Calculated values can detect the intensity of a change of speed when moving the body frame to the left and right. Analysis of the results with the ratio of diameters of sieves are recommend the use of cone-qualifier: - with a horizontal element in the top position with a speed in the range of 0.04 m / min to 0.07 m / min; - with a horizontal element in the neutral position at a rate of ranging from 0.06 m / min to 0.085 m / min; - with a horizontal element in the down position at speeds in the range of 0.075 m / min to 0.1 m / min.